Keba KeContact E10, Instructions Manual, Page: 6 / 34

E10 Introduction
V1.00
6
© KEBA 2023
1.2 Purpose of the document
This document describes the complete installation and configuration of KC-
E10.
1.3 Requirements
This document contains information for persons who meet the following re-
quirements:
Target group Required knowledge and abilities
Electrician
Person who, due to their special training, expertise and experience
as well as knowledge of current standards, is able to assess the
work performed and the possible hazards.
Knowledge about:
● Currently valid safety regulations
● The method of operation of an energy meter
● Displays and operating elements
● Basics of network technology
● Diagnostic options
● Systematic fault analysis and rectification
● Setting options
1.4 Intended use
The device is a measurement device that determines and supplies the elec-
trical measured values at the terminal. The data collected by the device may
deviate from the data of the main energy meter.
Information
This device is NOT an active electrical energy meter as defined by EU Di-
rective 2004/22/EC (MID) and therefore may only be used for internal ac-
counting purposes.
According to its classification, the device may be connected exclusively in
sub-distribution or sub-circuit distribution on the consumer side downstream
of the energy meter of the power supply company (PSC).
The device is suitable solely for use indoors. The respective national regula-
tions must be observed with regard to installation and connection.
Any other use of the device than that described under "Intended use" is con-
sidered improper use. Unauthorized changes, conversion work or repairs as
well as opening the device are prohibited.
The intended use of the device always includes the compliance with the en-
vironmental conditions for which this device was developed.