KBS Gastrotechnik TK 220 CHR, Instruction Manual

Page: 9 / 37

7
R E V I E W O F M E C H A N I C A L C O N T R O L ( f i g . 1 , 2 )
CONTROL PANEL — DESCRIPTION OF SYMBOLS AND OPERATIONS
1
− − − −
THERMOSTAT KNOB . The temperature in the appliance is controlled using the
thermostat knob by turning it to one side or the other. More in “Temperature regulation”.
3
−
− −
−
ELECTRICITY SUPPLY INDICATOR marked with the symbol
When the appliance is connected to the electricity supply, the green indicator light is
illuminated. Simultaneously also the
the temperature rise indicator lights up . It
indicates that the freezer was switched off for a longer time, i.e. the freezer is switched
on for the first time, after defrosting or after losing of voltage.
When the temperature in
the compartment again falls below -9 ºC, the temperature rise indicator light will go
out.
4
−
− −
−
THE TEMPERATURE RISE INDICATOR marked with the symbol
When the temperature in the freezer rises above -9 ºC, the red indicator light is
illuminated. It indicates that:
•
The freezer was switched off for a longer time, i.e. the freezer is switched on for the
first time, after defrosting or after losing of voltage.
•
The door of the freezer is opened or is being opened too frequently.
•
It is loaded a large amount of unfrozen foodstuffs.
•
The freezing system is failed, i.e. the indicator does not go out longer 6 hours and it is
heard running compressor or the compressor does not switch off. In this case you
should apply to your service agent (at first make sure that three above items were
taken into account).
P R E P A R I N G T H E A P P L I A N C E F O R O P E R A T I O N
It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Lift the appliance away from foamed polystyrene base.
To not rise or push freezer taking by handles. Handles may break.
•
Tear away the adhesive tapes – they are intended only for the transport of the appliance.
Remove the separate polystyrene part (transport protection) between the rear of the
device and condenser – metal grid (if available).
NOTE. When you open the freezer compartment door a little red packing detail will
fall out – IT IS FOR TRANSPORTATION PURPOSES ONLY.
•
When positioning the appliance in chosen location, it will move more easily into position if
you lift the front a little and incline it backward,
allowing it to roll on its casters.
•
Suitably dispose the packaging material.
•
Take two supports 1 from the bag and insert
them into the guides 2 at the top back part of the
appliance.
•
If the appliance is brought in from the cold
(temperature is not higher than +12 °C), you should wait for two hours before connecting
it to the mains.
•
The appliance should not be connected to the mains until all packing and transport
materials aren’t removed.