• 12 Volt use ONLY.
• Use in well vented area.
• Read owner’s manual before using.
• Contact with battery acid may cause severe burns and blindness.
• Failure to follow these instructions may result in personal injury, de-
struction of the jump starter, or damage to your vehicle.
• ALWAYS WEAR EYE PROTECTION (WEAR SAFETY GLASSES)
WHEN USING AND WHEN WORKING AROUND BATTERIES.
• WARNING – Risk of Explosion or Fire (ALL BATTERIES can release
hydrogen gas that is explosive and/or flammable).
Before using the jump start device it should be charged. Unlike ordinary
battery powered jump start devices, the Mini can be charged with as little as
10V and still provide enough power to start an engine. Differences in engine
size, engine oils, parasitic loads, and temperature may affect the amount of
charge needed. As a result, until you become familiar with the Mini’s charge
characteristics for your application, it is recommend to charge the device
prior to use. In most cases the charge process will take place between 90
and 180 seconds. If more than 5 minutes pass with the unit active, the unit
will automatically shut off and enter sleep mode. If the unit is left in “ON” po-
sition longer than 10 minutes, the device will enter sleep mode. To wake from
sleep mode press the boost button, or the activation switch down.
KrankingKART Mini HD jump start procedures.
To charge the KrankingKART Mini HD using a running
vehicle:
1. BE SURE the jump starter switch is in the “OFF” position.
2. Open the hood of a running vehicle and locate the battery.
3. Connect the RED POSITIVE (+) clamp to the POSITIVE terminal first,
then connect the BLACK NEGATIVE (-) clamp to NEGATIVE terminal.
4. If you accidentally connected the clamps backwards a warning LED will
light RED. If the warning LED is lit RED, DISCONNECT THE CLAMPS
IMMEDIATELY. DO NOT TURN THE JUMP STARTER “ON”. The unit
has safety features to prevent activation in this scenario, but care should
be taken to avoid this scenario.
5. Turn the device “ON” using the switch on the jump starter. LED should
illuminate green. If the LED is ORANGE, press and hold boost button to
recharge.
