To jump start a vehicle or engine:
1. Turn the ignition key to the “OFF” position and remove the key before
connecting clamps to the vehicle battery.
2. Be sure the jump starter switch is in the “OFF” position before the clamps
are connected to the battery.
3. Connect the RED POSITIVE (+) clamp to the POSITIVE terminal first,
then connect the BLACK NEGATIVE (-) clamp to NEGATIVE terminal.
4. If you accidentally connected the clamps backwards a warning LED will
light RED and the unit will disable itself. If the warning LED is lit RED,
DISCONNECT THE CLAMPS IMMEDIATELY. DO NOT TURN THE
JUMP STARTER “ON”, this could cause serious damage, or injury.
Reverse the clamp connections and the warning LED light should turn off
and stop.
5. Turn the device “ON” using the switch on the jump starter. LED should
illuminate green. If LED is Orange the “boost” button must be held in
during start attempt. The less time between switching the device on and
engine starting the better.
6. Start the engine. After starting the engine leave the jump starter at-
tached for approximately 3 minutes, or until unit has reached system
voltage. This will insure the jump starter is fully charged for its next use.
7. After 3 minutes turn the jump starter “OFF”. This is done by turning the
switch back to the “OFF” position.
8. After turning the jump starter “OFF” disconnect the jump starter clamps.
The BLACK NEGATIVE (-) first then the RED POSITIVE (+). Be sure
the jump starter is in the “OFF” position before disconnecting the clamps.
Failure to do so could cause damage.
9. The KrankingKART Mini is now ready to be used again, or to be placed
in storage.
If LED is RED after connecting cables:
1. Unit may be hooked up backwards (reverse polarity scenario). Check to
make sure unit is correctly attached to battery terminals. Follow instruc-
tion number 3 from list above.
2. System voltage could be above 16 volts. In this scenario LED will remain
RED, and the unit will not activate. Designed to work with 12 volt vehicles
only.
