STEP 4:
Now place the child carrier on the support bar and attach using
the thumb screw. The seat can slide back and forth to your preference.
WARNING:
The movability of the handlebar may be reduced by the
child seat. It may be necessary to change the type of handlebar you have
if the steering is reduced to less than 45º.
Once you have found the desired position, tighten the thumb screw.
Make sure all of the bolts and screws are carefully tightened before using
the child carrier. FIG 5.
When securing hardware, apply normal hand tightening using the tools
supplied/required. Torque requirements 10 Nm.
NOTE:
When you want to ride your bike without the child carrier, remove the child seat by loosening the thumb screw.
It is not necessary to remove the support bars.
Your seat has been equipped with a secure strap. Fit the strap around the mounting bar and tighten securely.
BEFORE YOU RIDE THE BIKE
The bicycle should be tested and the controls checked for proper function before
a child is placed in the child carrier. Take the bicycle for a test ride WITHOUT a
child in the carrier. Confirm that the bicycle child carrier does not interefere with
the safe operation of the bicycle before taking your child for a ride.
Before you take your child on the first ride in the bicycle carrier, you should try the
child carrier and adjust the security harness for a comfortable fit. Place the child
in the carrier with the child’s feet in the foot support enclosures by opening the
locking lever in the back. Make sure to lock this lever securely after the desired
height is reached. Position the shoulder straps on the child’s shoulders, with the
straps close to the child’s neck, and position the shoulder tension strap in the
upper shoulder area, to keep the straps from sliding off the child’s shoulders.
Adjust straps until they are comfortably snug when the child is sitting upright.
WARNING! Make certain your child is securely buckled into the
security harness before riding your bike.
WARNING! Never leave your child in the child carrier with the bicycle
supported only by the kickstand or leaning against a support.
6
FIG. 5
Black Thumb
Screw
press
To put the child in the seat, open
the buckle of the belt as indicated.
Before starting your ride, make
sure the seat belt is properly
adjusted and that it does not hurt
the child. This adjust-ment is
made by sliding the belt adjustors.
To adjust the height of the foot
rest that suits your child´s size,
lift the red lever and choose one
of the available positions. Close
the red lever.
SECURING CHILD IN CHILD CARRIER
CAUTION: Shoulder tension strap
should only used on child’s back,
never in the front chest area.
Summary of Contents for WALLABY
Page 2: ......
