4
5
Preparation
Power on for the first time, the display panel flashes for 1s,
and then the screen is turned off. The whole appliance is the
standby state;
Warm up
When the particulate matter sensor enters the
warm-up state, PM2.5 numerical display shows "--
-", and is normal after 10s.
Work
The purifier is powered on for the first time and
then enters the automatic mode.
On/standby
Press on/standby button
Install the filter
Remove the protective film of
the filter assembly.
Test Run
Attention
• This appliance has the function of disassembling protection, so it cannot be started normally until all
air inlet grilles are installed correctly.
• In case of continuous electricity, enter the working mode before the standby state, after each power
on.
• The appliance is connected to the power again after unexpected power outage (when the power is
off or the power cord is unplugged during normal operation), and then restores to the working state
before the power outage.
ON/STANDBY
1
2
3
4
5
6
