Kaysun Aquantia KHP-MO 4 DVR2, Installation & Owner'S Manual, Page: 62 / 88

58
T1s+dT1s
T1s
Compressor
Pump
t_interval_H
OFF
ON
OFF
ON
t_firstFH
t
When the cursor is on OPERATE PREHEATING FOR
FLOOR, Use
▼ ▲
to scroll to YES and press . The
following page will be displayed:
Press ▼ ▲ to scroll and press to enter.
During first operation of the unit, air may remain in the
water system which can cause malfunctions during
operation. It is necessary to run the air purge function to
release the air (make sure the air purge valve is open).
Go to > FOR SERVICEMAN> 12.SPECIAL
FUNCTION.
Before floor heating, if a large amount of water remains on
the floor, the floor may be warped or even rupture during
floor heating operation, in order to protect the floor, floor
drying is necessary, during which the temperature of the
floor should be increased gradually.
ENTER
12 SPECIAL FUNCTION
12.1 PREHEATING FOR FLOOR
12.2 FLOOR DRYING UP
If PREHEATING FOR FLOOR is selected, after press ,
the following page will be displayed:
12.1 PREHEATING FOR FLOOR
30 °C
72 HOURS
ADJUST
T1S
t_fristFH
ENTER EXIT
Use
▼ ▲
to scroll the cursor to YES and press , the
preheating for floor will turn off.
The operation of the unit during preheating for floor
described in the picture below:
During preheating for floor, all the buttons except are
invalid. If you want to turn off the preheating for floor,
please press .
The following page will be displayed:
12.1 PREHEATING FOR FLOOR
Preheat for floor is
running for 25 minutes.
Water flow temperature is 20°C.
CONFIRM
12.2 FLOOR DRYING UP
8 days
5 days
5 days
45°C
15:00
ADJUST
WARM UP TIME(t_DRYUP)
KEEP TIME(t_HIGHPEAK)
TEMP. DOWN TIME(t_DRYDOWN)
PEAK TEMP.(T_DRYPEAK)
START TIME
During floor drying, all the buttons except are invalid.
When the heat pump malfunctions, the floor drying mode
will turn off when the backup heater and additional
heating source is unavailable. If you want to turn off floor
drying up, please press . The following page will be
displayed:
12.1 PREHEATING FOR FLOOR
Do you want to turn off the preheating
for floor function?
CONFIRM
NO YES
12.2 FLOOR DRYING UP
01 -01-2019
ADJUST
START DATE
ENTER EXIT
12 SPECIAL FUNCTION
Active the settings and active the
“SPECIAL FUNCTION”?
CONFIRM
NO YES
If FLOOR DRYING UP is selected, after pressing , the
following pages will be displayed: