Kayoba 027481, Operating Instructions Manual, Page: 30 / 60

30
3.4.1 To fit the right pedal
1
Install the right pedal on the crank arm on the chain
side of the product, screw the pedal clockwise.
(Figure 6)
2
Tighten the bolt with a 15 mm combination wrench.
3.4.2 To fit the left pedal
1
Install the left pedal on the crank arm on the opposite
side of chain, screw the pedal counter-clockwise.
(Figure 7)
2
Tighten the bolt with a 15 mm combination wrench.
3.5 To install the saddle post and the
saddle
1
Put grease on the saddle post.
2
Install the saddle post into the seat tube.
Note! Make sure that the marking for the top position on the
saddle is below the edge of the seat tube.
3
Lock the saddle post to applicable height with the
quick-release lock.
4 Operation
4.1 To do before the operation
● Make sure that the saddle and the handlebars are
adjusted correctly. (Figure 8)
● Make sure that the product is assembled with brakes and
a bell.
● Make sure that the product has a front lamp with a white
light and a rear lamp with a red light. Make sure the
lamps can be lit.
● Do a check of the reflectors on the product. Make sure
that they are correctly installed, clean and not obscured.
Replace damaged reflectors.
● Learn how to use the components and accessories on
the product correctly.
● Make sure that the brakes stop the wheels when applied.
● Make sure that the brake pads are not worn out.
● Make sure that all screws and components are tightened
and correctly installed.
● Make sure that the wheels are correctly installed.
● Make sure that the rims are not damaged.
● Make sure that the tires are not damaged. Make sure that
the tires have the correct air pressure.
● Make sure that the steering moves correctly.
4.1.1 To adjust the position of the saddle
1
Loosen the bolt under the saddle (A) and move the
saddle to an applicable position. Move the saddle
with small adjustments to find the correct position.
(Figure 9)
Note! If you have your foot on the pedal with the crank arm
horizontal, the pedal should stay vertical below the knee.
2
If it is needed, adjust the angle of the saddle. Tighten
the bolt.
4.1.2 To adjust the height of the saddle
1
Open the quick-release lock and adjust the height of
the saddle (B). (Figure 9)
Note! Make sure that the marking for the top position (C) on
the saddle is below the edge of the seat tube. (Figure 9)
2
Close the quick-release lock.
4.2 The brakes
Warning! Do not use the product with brakes that do
not work correctly.
Warning! If you do not learn how to use the brakes on
the product you can get seriously injured.
● The product has a hub brake at the rear and a rim brake
at the front.
● The rear brake is engaged when you pedal backwards.
● The front brake is engaged when the brake lever is
pressed to the handlebar.
4.3 To use the brakes
Warning! Do not apply the front brake when you turn
the product or when on a slippery surface.
● Apply the rear brake before you apply the front brake.