Kayoba 027481, Operating Instructions Manual, Page: 29 / 60

29
3 Assembly
3.1 Tools for assembly and adjustment
● Combination wrenches, size 8, 10, 13, and 15 mm.
● Hex keys, size 5, 6 and 8 mm.
● Screwdrivers.
3.2 To assemble the handlebars
1
Make sure that the brake wires are put on the right
side of the front fork. If the wires are not installed
correctly, rotate the wires to the correct position.
2
Apply grease to the hole in the front fork and the bolt
at the lower part of the handlebars.
3
Install the handlebars at an applicable height in the
hole in the front fork. Make sure that it is deep
enough to be stable.
4
Make sure that the handlebars are straight and have
a correct angle. Tighten the clamping screw with a 6
mm hex key. (Figure 2)
5
Install the bell (8) and tighten the screws. (Figure 1)
3.3 To assemble the front wheel
1
Push the top parts of the front brake together and
unhook the brake wire so that the brake separates.
(Figure 3)
2
Place the front wheel into the front fork, with the tire
in the correct direction of rotation.
3
Make sure that the front wheel is centred between
the fork legs. Tighten the nuts alternately. (Figure 4).
4
Push the front brake together and install the brake
wire. (Figure 5)
5
Install the front mudguard (12) and the bike stand (18).
Tighten the screws. (Figure 1)
3.4 To assemble the pedals
Caution! Install the right pedal on the right side of
the bike, and the left pedal to the left side of the bike. If the
pedals are not installed correctly, it can cause damage to
the threads on the pedals.
2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● The instructions describe how to ride safely and keep the
product in good condition. Read the instructions carefully
and follow them.
● The product is a vehicle. Always follow local traffic
regulations.
● The maximum load is 120 kg, rider and baggage included.
● Do not let a passenger sit on the product.
● Always wear a bike helmet.
● If it is dark, use the lamps on the product. Wear bright
clothes, if it is possible.
● If it is wet, the power of the brake is reduced. Cycle more
slowly and apply the brake earlier than in dry weather.
● Do not modify the product.
● The product must only be used for its intended purpose.
● Do not use the product if you are tired, ill or under the
influence of alcohol, drugs or medicine. This has a
negative effect on your vision, alertness, coordination and
judgement.
● Do not use the product if it is damaged.
● Do not put anything on the carrier rack that will affect the
steering of the product or get caught up in the rear
wheel.
● Do not hang anything on the handlebar that will affect
the steering of the product or get caught up in the front
wheel.
● Do not try to do any stunt on the product.