Kayoba 022176, Operating Instructions Manual, Page: 24 / 52

24
2023_001
3 Assembly
3.1 Tools for assembly and adjustment
● Combination spanners, size 8, 10, 13, 15 mm.
● Hex keys, size 5, 6 and 8 mm.
● Screwdrivers.
● Grease.
3.2 To assemble the handlebars
1
Make sure that the brake wires are put on the right
side of the front fork. If the wires are not installed
correctly, rotate the wires to the correct position.
2
Apply grease to the hole on the front fork and the
expander bolt at the foot of the handlebars.
3
Install the handlebars at the required height in the
hole on the front fork. Make sure that it is deep
enough to be stable.
4
Make sure that the handlebars are straight and
tighten the clamping screw with a 6 mm hex key
(Figure 2).
5
Install the bell and the front reflector, tighten all
screws; position 8 and 9 (Figure 1).
3.3 To assemble the front wheel
1
Push the top parts of the front brake together and
unhook the brake wire so that the brake separates
(Figure 3).
2
Hook the front wheel into the front fork, with the tire
in the correct direction of rotation.
3
Make sure that the front wheel is centred between
the fork legs. Tighten the nuts alternately (Figure 4).
4
Push the front brake together and install the brake
wire. (Figure 5).
5
Install the front mudguard and bike stand tighten all
screws position 12 and 18 (Figure 1).
3.4 To assemble the pedals
Note! Install the right pedal on the right side of the bike, and
the left pedal to the left side of the bike. If the pedals are not
installed correctly, it can cause damage to the threads on
the pedals.
2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● The instructions describe how to ride safely and keep the
product in good condition. Read the instructions carefully
and follow them.
● The product is a vehicle. Always follow local traffic
regulations.
● Do not let a passenger sit on the product.
● Always wear a bike helmet.
● If it is dark, use the lamps on the product. Wear bright
clothes, if it is possible.
● If it is wet, the power of the brake is reduced. Cycle more
slowly and apply the brake earlier than in dry weather.
● Do not modify the product.
● Do not use the product other than what it is intended for.
● Do not use the product if you are tired, ill or under the
influence of alcohol, drugs or medicine. This has a
negative effect on your vision, alertness, coordination and
judgement.
● Do not allow any children or anyone who is unfamiliar
with the product to use it.
● Do not use the product if it is damaged.
● Do not put anything on the carrier rack that will affect the
steering of the product or get caught up in the back
wheel.
● Do not hang anything on the handlebar that will affect
the steering of the product or get caught up in the front
wheel.
● Do not try to do any stunt on th product.
EN