EN
40
2. Holder
FIG. 2
Removal
1. Take off the front frame (a) by gripping
its slots with your fingers and pulling out.
(When refitting the frame the side with
the slot should face down.)
2. Insert the supplied removing tools in
the slots on both sides of the main unit
until they click in place. Pull the tools (b)
out to remove the main unit from the
dashboard.
FIG. 3
Installation on back DIN fastener
Installation with the screw holes in the sides of
the main unit. Follow the instructions below to
fit the main unit on the supplied brackets.
1. Align the brackets so that their holes are
opposite the screw holes in the main unit,
insert screws at two points on each side, and
tighten.
2. Screw
3. Supplied bracket
4. Dashboard
5. Hook (to be removed)
FIG. 4
NOTE:
The box shaped holder and the outer
decorative frame are not used for this type of
installation.
DETACHING FRONT PANEL
Removing front panel
1. Disconnect the power supply.
2. Press the lock button on the front panel.
12. Selection of programme source and end call
13. Shortcuts (preset radio stations)
14. Stepping button for frequency setting and
track selection
15. Input for external device (AUX IN)
FIG. 1
INSTALLATION
• Function test the product before
permanent installation by connecting and
testing all the functions.
• Only use the supplied parts for the
installation. The use of other parts can
result in malfunction.
• The product should be installed by an
authorised service centre, otherwise the
warranty will not be valid.
• Install the product so as not to interfere
with the driver and so it cannot injure the
passenger when braking hard or in a
collision.
• Do not install the product where it can be
exposed to heat, direct sunlight or hot air,
dust, dirt or strong vibrations.
• Remove the front panel before installing
the product.
DIN FASTENER, FRONT/BACK
The main unit on the product can be installed
on the conventional front DIN fastener or
on the back DIN fastener with the threaded
holes in the sides of the main unit chassis. See
descriptions below (method A and B).
Installation of main unit
Put the holder in the dashboard and use
the fasteners that suit the thickness of the
dashboard. Bend in the fastener to fix the
holding sleeve in the dashboard.
1. Dashboard
