Kawneer reserves the right to change configuration without prior notice when deemed necessary for product improvement.
© Kawneer Company
, Inc., 2013
Laws and building and safety codes governing the design and use of glazed entrance, window
, and curtain wall products vary widely
. Kawneer does not control
the selection of product configurations, operating hardware, or glazing materials, and assumes no responsibility therefor
.
6
kawneer.com
EC 97904-076
Kawneer 1786 Rim Exit Device
INSTALLATION INSTRUCTIONS
APRIL, 2018
038311EN
FINAL ASSEMBLY
1)
Slide pivot stile filler plate into exit device and attach pivot stile end cap with fasteners provided.
(Filler plate with cylinder dogging has been installed previously)
2)
Slide lock stile filler plate into exit device.
3)
Install housing cover brackets onto top and bottom of exit device with fasteners provided.
4)
Install housing cover over brackets and attach with (Black) fasteners provided.
HOUSING COVER
END CAP
PIVOT STILE
FILLER PLATE
LOCK STILE
FILLER PLATE
HOUSING COVER
BRACKET & FASTENER
1)
Prep door jamb for strike as shown below.
ADJUST STRIKE AS REQUIRED
TRIFAB 450 SHOWN
TRIFAB 451 SIMILAR
BOTTOM
1.875
FIN TO BE MILLED
FLUSH WITH FACE
OF MULLION
CL
0.149 Ø THRU HOLE
TAP FOR #10-24 UNF-2B
(2) PLACES
0.438
0.438
3.580
0.938
0.375
0.750
0.312
0.812
0.128 DIA. (4 PLS)
40.000 + BTM DOOR CLEARANCE
(40.687 W/ STD 1
1/16" CLEARANCE)
2)
Attach strike to door jamb with fasteners provided.
3)
Close door and adjust strike as required to hold door
tight against weathering.
4)
Attach stainless steel rub plate with (4) 1/8" drive
rivets provided.
STRIKE INSTALLATION AND ADJUSTMENT
LEFT HAND SHOWN
RIGHT HAND OPPOSITE
HOUSING COVER
FASTENERS (Black)
END CAP
FASTENERS
(Black)
NOTE:
Rub plate for 1-3/4" door (133643)
included with exit device.
Rub plate for 2" and 2-1/4" door (133644)
order separately.
