kawneer.com
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2013
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
1
038310
EC 95424-057
40"
40-13/16"
KAWNEER 1686 CONCEALED EXIT DEVICE
INSTALLATION INSTRUCTIONS
FEBRUARY, 2015
TOP GUIDE INSTALLATION:
1) Install top guide over top bolt and slide into door stile.
2) Attach guide with (2) #10 x 1/2" FH undercut fasteners.
BOTTOM GUIDE INSTALLATION:
1) Install bottom guide over bottom bolt and slide into door stile.
2) Attach guide with (2) #10 x 1/2" FH undercut fasteners.
Cylinder dogging pawl
Cylinder
CL
Device
CL
Bottom of door
REMOVAL OF CYLINDER DOGGING PAWL:
1) Loosen two bracket retaining fasteners.
2) Discard dogging pawl.
3) Reinstall the bracket and retaining fasteners within the exit device housing.
Bracket
CENTER CASE INSTALLATION:
1) Using a hook tool, align center case with holes provided.
2) Attach center case with (2) #8 x 1/4" cap screws (don't over tighten).
3) Adjust top and bottom bolts with wrench provided allowing bolt to extend
beyond stile. Turn top and bottom bolts counterclockwise to lengthen and
clockwise to shorten.
ROD AND CENTER CASE ASSEMBLY:
1) For inactive doors or doors without exterior cylinder, or doors without the
need for exterior cylinder dogging, the removal of the cylinder dogging
pawl is required. (See removal of Dogging Pawl below)
All active doors with cylinder locking will require the cylinder dogging
mechanism to be activated before rod and center case assembly is inserted
into the active door stile.
Slide rod and center case assembly into active door stile.
The 190 active pair door will require the weld nut plate fasteners to be cut
flush with nut plate to allow center case assembly to insert into a 190 door
stile extrusion.
Do Not Over
Tighten Screws
