Instructions for use SMARTmatic S10 REF 1.011.6730 SMARTmatic S10 K REF 1.011.6731 SMARTmatic S10 S REF
1.011.6732
5 Operation | 5.4 Removing a straight or contra-angle bur
14 / 30
WARNING
Use of unauthorized burs.
Risk of injury.
▶ Comply with the instructions for use and the intended use of the bur.
▶ Only use burs that do not deviate from the specified data.
CAUTION
Use of burs with worn or damaged shafts.
Risk of injury, tool may fall out during treatment.
▶ Never use burs with damaged or worn shafts.
CAUTION
Danger of injury from bur.
Infections or cuts.
▶ Wear gloves or finger guards.
CAUTION
Hazard from defective chucking system.
The bur could fall out and cause injury.
▶ Pull on the bur to check if the clamping system works properly and the bur is
firmly clamped. Wear gloves or a finger guard to check, insert or remove the bits
to prevent injury and infection.
NOTICE
Tool shaft slips inside the chuck due to excessive speed of the tool or abrupt engage-
ment of the tool.
Property damage to tool shaft and chuck system, reduction of the service life of tool
and chuck system.
▶ Do not operate the tool at a higher speed than recommended by the manufac-
turer.
NOTICE
Use of burs with worn or damaged shafts.
Property damage to the chuck system, tool is difficult or impossible to remove from
the chuck system.
▶ Do not use burs with damaged or worn shafts.
▶ Hold the gripping sleeve firmly, rotate the taper sleeve in the direction of the arrow
to the stop and insert the handpiece bur in the chuck.
▶ Turn the taper sleeve back into its initial position.
▶ Check that the bur is securely attached by pulling on it.
5.4 Removing a straight or contra-angle bur
WARNING
Hazard from rotating bur.
Lacerations and damage to the chuck system.
▶ Do not touch the bur while it is rotating!
▶ Remove the bur from the handpiece after treatment to avoid injury and infection
when putting it away.
▶ After the bur has come to a standstill, turn the taper sleeve ring in the direction of
the arrow to the stop and remove the bur.
