Instructions for use EXPERTsurg LUX – 1.008.3500
5 Operation | 5.4 Defining and running program steps
34 / 68
NOTE
Follow the instructions for use, service instructions and assembly instructions
enclosed in the motor, handpiece and contra-angle handpiece packaging.
4
Pull the coolant hose off the straight or contra-angle handpiece.
4
Twist the straight or contra-angle handpiece slightly to pull it off.
5.4 Defining and running program steps
The EXPERTsurg LUX is based on program steps and associated activities and
can be operated intuitively using the graphical user interface.
1
2
Program step 1: Marking
The current program step is shown on the display as a number
①
and the cor-
responding activity is shown as a symbol
②
. Each program step can be as-
signed to any activity by selecting the corresponding symbol.
Visualizing the activity is an easy means for checking if the activity set on the
device is the same as the current treatment step. Operating errors can thus be
largely prevented.
Default values have been set at the factory for the parameters, speeds,
torques, transmission ratios and coolant flow rate, for every activity according
to application. The parameters can be changed only within a reasonable range
for the specific activity. In the activity, "Free application", all available values
can be set. The table below lists the ranges of values and factory settings.
A treatment sequence can consist of 4 to 10 program steps and/or activities.
The treatment sequence can be designed individually through any arrangement
of the activities. Navigate with the foot control during the sequence such that
the device does not have to be touched again during the intervention.
Changed values are saved automatically and are then available for the next
use.
