Instructions for use ERGOcom 3
4 Start-up
|
4.2 Setting up the RF receiver for ERGOcom 3 excellence
4.2.2 Learn channel
The dedicated code of each KaVo wlink device is synchronised to the specific chan‐
nel configured on ERGOcom 3.
▶ Hold down the Channel Selection button on ERGOcom 3 for more than 2 se‐
conds.
Learn Channel Mode appears on the status display.
Note
If the channels do not synchronise within approximately 30 seconds,
ERGOcom 3 returns to operating mode.
▶ Hold down the Wake Up/Learn button on the ERGOremote for more than 3 se‐
conds.
The green LED will flash to indicate that the ERGOremote learn channel mode
is active.
The green LED will be lit for 3 seconds to show that synchronisation is complete.
Note
If the LED does not illuminate for 3 seconds to show that synchronisation is com‐
plete, the ERGOcom 3 is either not in learn channel mode or the wireless connec‐
tion has been broken (out of range, aerial problems, obstructions in room).
18/54
