7/12
EN
Application
BEFORE EACH USE MAKE SURE THE WORKTABLE IS LEVELLED AND STABLE.
Application
In case of truncation cutting it is recommended to carry out the incision alongside the aluminium sticks; if necessary it is possible to pull two
sticks together to have a bigger support surface.
Loosen the handles (A) on both bar holders (B) and (C), extend the worktable by levering on the profiles (D) by grabbing them in correspondence with the bars holder.
It is recommended to proceed with steps of 10-20 cm (3
15/16”
- 7
7/8”
), indicated with incisions, in an alternated way on every bar holder (B) and (C). The worktable is
extendible from 100 to 150 cm (from 3’ to 5’). Adjusted the length, fasten the handles (A).
Once opened the worktable of the desired length it is possible to modulate again the profiles (E) by slightly unscrewing the knob (F) and making the profile
translate to the right or to the left (E). It is possible to use, for the most common lengths (120 and 150 cm) (4’ and 5’), the seats (G) placed on the bars holder.
A
A
B
C
D
D
a
a
10 cm /
3
15/16”
F
E
G
G
