52
SEARCH CHANNELS (CHANNEL SEARCH)
The
buttons allow you to select different sets of parameters for the scan.
Satellite
Use the
buttons to select the satellite on which the transponder you wish to scan is located. Make
sure your reception system is aligned to the selected satellite. You can search only one transponder at a
time. If you wish to search several transponders on a satellite, you should start an automatic search of the
transmitting satellite.
Press the
button to move to the next selection item.
Transponder frequency
Select the transponder to be scanned, using the
buttons or the keypad. At the bottom right of the
screen display, the receiver shows the current signal strength and signal quality of the selected transponder.
Press the
button to move to the next selection item.
Polarisation and symbol rate
These settings must only be adjusted if you intend to scan a transponder that has not yet been saved by the
receiver. Adjust settings using the
buttons or the numeric keys.
Channel Search Mode
Use the
buttons to select whether you wish to search “free & encrypted” or “only free” channels.
Press the
button to move to the next selection item.
Network Search
Use the
buttons (On/Off) to select whether a network scan should be performed. If you set the
network search to “Off”, only the factory stored transponders of the satellites you previously selected will be
searched for new as yet unlisted channels.
If you set the network scan to “On”, the transponder network enables additional transponders that have not
yet been stored to be located. They are then stored and searched for new channels in the same way as the
existing transponders.
When you have made your settings, use the
buttons to select “Start Search” and press the
button to start scanning. You can cancel the scan at any time by pressing the
button.
During the search you will see a display that shows you the progress of the search and the channels found
so far. Newly found channels are identifi ed with the designation “New” after the channel name.
