3 / 10
●
The equipment described is designed solely for the installation of satellite
receiver systems.
●
Any other use, or failure to comply with these instructions, will result in
voiding of warranty cover.
●
Install the device in dry indoor areas only. Do not install on or against
highly combustible materials.
●
Make sure that the devices are equipped with an equipotential bonding
conductor (Cu, at least 4 mm
2
).
●
Make sure to comply with the safety regulations set out in the current EN
60728-11 and EN 60065 standards.
●
Fixings: Screws, max. Ø: 4 mm
●
Connectors: RF connector 75 Ω (F series) to EN 61169-24.
●
Terminate any unused RF ports with 75-Ω resistors, e.g. EMK 03.
●
To meet EMC requirements, the only power supply unit allower to be used
is the NCF 18.
Current-carrying device NCF 18
●
Do not open the unit or tamper with it.
●
When working on the system, always unplug the power supply unit from
the wall socket.
●
The device is intended only for wall mounting.
All other installation positions are prohibited.
●
Ensure adequate clearance to all sides
of at least 5 cm.
●
Risk of overheating! Risk of overheating! Make sure there is free circulation
of air to dissipate the heat from the unit.
●
Operate the device/power supply unit only in the permissible ambient
temperature range of –20 to +55 °C.
Please note:
●
Do not place any liquid-filled items on top of the power supply unit.
●
Do not expose the power supply unit to dripping or splashing water.
●
Ensure that the power supply unit is easily accessible and operable.
●
Bear in mind that the only reliable method of disconnecting the unit from
the mains is to pull the plug of the power supply unit out of the mains
socket.
●
If the inner cable
conductor diameter is
more than 1.2 mm, or if
burring is present, the
device sockets may be
destroyed.
Max. 2 mm
excess length
Clamping torque
3.4 Nm max.
(danger of over-
winding)
Diameter
0.6-1.2 mm
free of burrs
Installation and Safety Instructions
