Installation of KAT WALK PREMIUM Shell
We have equipped the product with KAT WALK PREMIUM shell for the purposes of aesthetics and protecting the mechanical
engineering. The shell is made of ABS materials, and if you find any damage to the shell upon receiving it, please timely
contact KAT service center.
Installation of Support Pillar Shell
The support pillar shell is made up of the right section and the left one connecting with each other. It is divided into four
pieces that are located on the upper, lower, right and left side, which are fixed with screws.
1.First install the upper part of the shell and tighten it with screws. Two screws along the diagonal line have been
installed on the girder, the remaining two screws along the other diagonal line needs to be installed at the connection
part between the support pillar shell and the girder, while only one screw needs to be installed at the connection
part between the shell and the sheet metal parts. The fixing flange plate is to be placed between the shell and the
sheet metal parts.
2.After finishing the installation of the upper part, start to install the lower part of the shell. Please note that now only
half piece of the shell is to be installed first and only the connection between the shell parts needs to be installed with
screws; there is no need to install screws at the screw holes on the lower end of the shell sides
Screw-E2
Screw-E1
Fix the flange
Place the wire
inside the housing
No need to
fix screw
No need to
fix screw
25 Starting Installation
