KASTOR SAGA-22 T, Installation And User Manual

Page: 33 / 50

8
- At the sides, there should be stones to the level of the sides, and in the middle, only half a stone can raise above the side
level.
Are the stones too tightly packed?
- Place the stones loosely, so there will be enough space between the stones.
Are the stones of good quality and the right size?
- Use peridolite or dunite stones, min. 10 cm in diameter. Flat stones are placed in an upright position
The sauna room won't become warm enough.
Are the doors, windows and air conditioning closed, and the combustion air opening open?
Is the sauna new, are the wooden structures damp for some other reason?
Is the heater used correctly?
Have you burned enough wood in the furnace?
- Burn according to instructions.
Is the draft too strong?
- Use the damper to adjust the draft.
Is the draft too weak?
Has the heater been sized correctly?
Is the draft height (chimney height) sufficient for the surrounding environment?
- If there are trees close by, a steep hill etc., the chimney needs to be over 3.5 m measured from the floor.
Is the amount of stones correct?
- At the sides, there should be stones to the level of the sides, and in the middle, only half a stone can raise above the side
level.
Are the stones too tightly packed?
- Place the stones loosely, so there will be enough space between the stones.
Are the stones of good quality and the right size?
- use peridolite or dunite stones with a minimum diameter of 10 cm. Place flat stones vertically.
The sauna heats up quickly, but the stones are not hot.
Is the amount of stones correct?
- At the sides, there should be stones to the level of the sides, and in the middle, only half a stone can raise above the side
level.
Are the stones too tightly packed?
- Place the stones loosely, so there will be enough space between the stones.
Is the heater too big?
- Keep the ventilation valve open to keep extra heat out. This way the stones will have time to heat up as well.
It will take a bit longer to heat the sauna this way.
There are black flakes under the heater.
The stones may be weathered.
The flakes can be metallic anvil cinder, fallen off the heater. The heater has been heated too much red-hot; the metal will
flake and the heater will break prematurely.
Do not heat the sauna heater so that the cover is constantly red-hot
There's a smell of sulphur in the sauna.
The stones have sulphur residues from blasting, or the stone includes sulphur naturally.
11. Manufacturer's declaration
This product fulfils claims mentioned in the certificate of approval and documents related to it.
www.tylohelo.com
12. Warranty and manufacturer identification
WARRANTY
Helo products are reliable and of high quality. Helo Oy grants a 2-year factory warranty to its Helo wood-burning sauna
heaters covering manufacturing defects. For products in public and commercial use, the warranty is valid for three months.
Damages caused by incorrect use or use which is not in accordance with instructions will not be covered by the warranty.
MANUFACTURER
TylöHelo
Pohjoinen Pallbontie1
10940 Hanko Finland
Tel. +358 (0)207 560300
www.tylohelo.com