5
4
PRE-INStAllAtION INfO
INStAllAtION
chEcK cONtENtS
Separate all parts from the packaging and check each part with the pack
contents section. Pay attention to the variations of the different models.
Make sure all parts are accounted for before discarding any packaging
material.
If any parts are missing, do not attempt to install your electronic faucet until
you obtain the missing parts.
WARNINg
1) To avoid reflection problems keep
a distance of more than 300 mm.
between the sink and the spout.
2) This faucet model, with an infrared
sensor pointing down, is not
intended to be used together with a
sink of a reflective material such as
stainless steel.
3) If a sink strainer is straight below
the faucet sensor, use a strainer with
a non reflective finish (do not use a
chrome plated one).
Min 300 mm.
Bottom of the washbasin
PREPARAtION fOR INStAllAtION
Flush the water supply lines thoroughly before installing the
faucet. Do not allow dirt, teflon tape or metal particles to enter the
faucet. Shut off water supply.
ImPORtANt
All plumbing is to be installed in accordance with applicable codes
and regulations.
Installations in Australia and New Zealand must comply with the
requirements of AS/NZS 3500.
StEP 1 – INStAllING thE fAucEt
1
Shut off the water supply.
ONE INLET
TWO INLETS
2
Cut an adequate opening in
the wall for the dimensions
of the product base, and the
corrugated tube.
3
Dismantle the faucet base.
4
Drill 4 small holes for the
product base support and
drive the anchors in.
80mm
80mm
