Kasco J Series, Owner'S Manual, Page: 10 / 14

10
fountains will keep some amount of ice open through
the winter. However, when the water is thrust into
the air, it is exposed to the colder air temperatures
longer and can actually make ice thicker on the pond/
lake. Storage over winter is best in a location that is
out of the sun and cool, but above 32
O
F. When storing
units during the offseason, it is important to store them
upside down if they are going to be sitting for long
periods of time. Units that sit upright on a shelf for
many months, or even years have a greater likelihood
of seals drying out. Storing upside down will ensure
oil is lubricating the seals and prevent drying.
CLEANING: Fountains should be removed from the
water at least once per year (at the end of the season
in cold climates) to clean the exterior of the system,
especially the stainless steel motor housing (can). The
motor housing is the surface that dissipates heat into
the water and any algae, calcium, etc. build-up will be-
come an insulator that blocks heat transfer. In warmer
regions it is recommended that the motor is removed
and cleaned at least two to three times per year de-
pending on conditions. In most cases a power washer
will be sufficient if the unit and algae are still wet.
SEAL AND OIL REPLACEMENT: This is a sealed
motor assembly and seals will wear out over time
(similar to brake pads on a car). Replacement of the
seals and a change of oil after three years may add
longevity to the operation of the motor, saving you the
cost of more expensive repairs. In warmer climates
where the fountain runs most or all of the year, it is
a good idea to replace seals more regularly than you
would need to in colder climates where the unit is
removed from the water for several months.
Seal replacement and all other repair services should
be performed by Kasco Marine or a Kasco trained
Authorized Repair Center. Any alterations or changes
made to Kasco units by an unauthorized source will
void the warranty. This includes tampering with the
unit, power cord, and/or control box. Please contact
Kasco Marine, Inc. at 715-262-4488 for your nearest
Authorized Repair Center.
ZINC ANODE: A Sacrificial Zinc Anode is supplied
on the shaft for protection of the equipment from cor -
rosion and electrolysis. The zinc anode should be up-
dated (replaced) if reduced to half the original size or
if white in color. Corrosion from electrolysis is more
commonly associated with saltwater or brackish water,
but as a matter of precaution, it is important to periodi-
cally check the zinc anode in all installations (at least
every two to three months).
Warranty Policy
Warranty Period:
Models:
3400JF, 3400HJF, 4400JF, 4400HJF - 2 years
Kasco Marine, Inc. warrants this Fountain to be free
from defects in material or workmanship (except for
the ropes, power cord, and propeller) under normal
use and service. The Kasco Marine, Inc. obligation
under this warranty is limited to replacing or repairing
free of charge any defective part within the warranty
period from the date of shipment. Customer shall pay
shipping charges for returning the unit to Kasco or an
Authorized Repair Center.
THIS WARRANTY IS IN LIEU OF ANY OTHER
WARRANTIES, EXPRESSED OR IMPLIED, AND
ANY OTHER OBLIGATION OR LIABILITY
WHATEVER ON THE PART OF KASCO MARINE,
INC. AND IN NO EVENT SHALL KASCO MA-
RINE, INC. BE LIABLE FOR ANY SPECIAL OR
CONSEQUENTIAL DAMAGES.
Warranty is void if:
• The Fountain is not maintained properly according
to the Maintenance Recommendations supplied in
this Owners Manual.
• The Fountain is returned for repair without the
power cord or if the unit, control box, or power
cord are altered in any way from original ship-
ment. Cuts in the power cord are not covered
under warranty.
• The Fountain is damaged by unauthorized tamper-
ing.
• The Sacrificial Zinc Anode around the propeller
shaft shows significant deterioration. (The Anode
must be inspected periodically and replaced if
necessary.)
Warranty Claim Procedure:
Check the eleven-digit serial number printed either on
the black cover of the motor or on the blue nameplate
and determine the year of manufacture according to