HYDRA
FORCE
HYDRAFORCE LIFT STATION AGITATOR MANUAL
13
11. Attach one snap hook (H) to one end of each 18"
chain (I).
ASSEMBLY INSTRUCTIONS (CONT.)
13. Thread the two chains (I) on one end of the
diffuser base through the middle of the diffuser
loop (P).
14. Attach the free end of both chains (I) to one snap
hook (H). Repeat for chains on other end.
12. Secure each snap hook (H) with chain (I) to
each of the four retrieval holes on the diffuser
substrate connector (N).
15. Secure the two snaphooks (H) with chains
to the loop in the cable (F).
H
I
11
12
H
I
N
I
P
H
13
14
H
F
15
16.
Determine the length of cable (F) needed to submerge diffuser assembly in lift station. For optimal
performance, the diffuser should be submerged 3-4'.
It is important that airflow from the diffuser does not enter a running pump. If start/stop controls are
in place, the diffuser can be placed at the bottom of the lift station. Ensure the compressors are turned
off when the pumps are running and turned back on when the pumps are off. If no controls exist,
submerge diffuser head above the pump inlet to avoid cavitation in the pump. Water levels may need
to be increased for proper mixing and operation.
Back to Contents
