3. Insert the axle and stirrer blade into the pot. You can do this either before
or after adding food. The stirring blade will sit slightly above the pot bottom,
and may lean slightly to the side. Do not worry as this will straighten itself and
align with the bottom once the motor unit is attached and blades start turning.
If you insert the blades after adding food twist the stirring blade into the pot as
far as possible until it reaches the bottom. The blades will “ dig into the food”
once the motor unit is attached and starts turning.
4. Attach the bridge while ensuring that axle comes through the center hole.
Use your thumb and remaining fingers to squeeze open the clamp on both
sides to place the bridge over the pot edge. Make sure you press the bridge
thoroughly down so the surface of the bridge touches the pot edge.
5. Let go of the clamp and it will fasten around the pot edge and secure the
bridge firmly.
6. Attach the motor unit by placing it in the bridge motor cradle and twisting
slightly counterclockwise. When the motor unit “point”aligns with the bridge
direction it is correctly placed.
7. You are ready to stir!
9. The LED light indicates if you start to run out of battery. In this case the unit
will also make an alarm sound. To stop the alarm insert the charging plug in
the motor unit’s charging socket. The alarm will stop if press on/off to stop the
stirrer.
10. To stop the stirrer simply press the On/Off button again
11. Remove the motor unit by turning it clockwise and lifting it up from the
bridge.
12. Remove the bridge from the casserole by squeezing the clamping mecha-
nism on both sides and lifting it off the casserole.
13. Carefully lift the stirring blade out of the casserole holding the axle. Be
careful of dripping hot food.
12
ENG
MESCOLÌ
INSTRUCTION MANUAL
