Karma KS-242, Owner'S Manual, Page: 55 / 72

46
Figure 8.4

Adjusting the Seat Height
●
The seat post rests on a seat height adjustment pin that runs through the center of
the frame post. There are three holes in the frame post that allow you to adjust the
seat height to 17.5"(44.5 cm), 18.5"(47 cm) or 19.5"(49.5 cm). The adjustment pin
is nestled between the two batteries and is hidden behind the main wiring
connected from the central relay box (controller) to the front of the scooter.
●
To adjust the seat height, remove the seat by following the previous instructions.
Next, remove both bolts from the two frame posts. (You might want to disconnect
the batteries to allow more room to work). Place the pin in the desired hole and
move the wiring back into its place. Then install the seat following the previous
instruction. Seat height adjustment is completed.
●
Slide the upper frame post up or down to the desired position. Place the seat
height adjustment bolt in the lowest hole (of the upper frame post) and tighten its
hex nut using two 17 mm wrenches. Use one 17 mm wrench to insert the threaded
stability bolt in the second lowest hole (of the upper frame post which is also
threaded).
●
Now you can replace the rear casing and install the seat following the previous
instructions.