Kärcher WD 4.200, Operating Instructions Manual

Page: 13 / 150

– 8
 Illustration
Connect accessories.
 Illustration
Plug in the main plug.
 Illustration
Turn on the machine.
몇
Work only with a dry cartridge filter!
Recommendation : To vacuum fine dust,
use the filter bag.
(see description / illustration )
 The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
 Caution : Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
몇
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er
.
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
 Illustration
Connect the suction hose to the blower
connection, this will activate the blower
function.
 Turn off the appliance.
 Illustration
Hook the floor nozzle into the parking
position.
 Turn off the appliance and disconnect
the mains plug.
 Illustration
Remove the appliance head and empty
the reservoir.
 Illustration
Stow away the mains cable, the mains
cable retraction and accessory in the
appliance.
Store the appliance in a dry room.
Start up
Dry vacuum cleaning
Wet vacuum cleaning
Blowing function
Interrupting operation
Finish operation
Empty the container
Storing the appliance
13 EN