Kärcher VC 6 Cordless ourFamily, Instructions Manual

Page: 10 / 16

10 English
Removing the battery
몇 WARNING
Uncontrolled startup
Risk of injury
Remove the battery from the device before service and
care work or if the device is not going to be used for a
long period of time.
1. Press the unlocking button.
2. Remove the battery from the device.
Illustration J
Operation
LED display
The LEDs on the head of the device and on the battery
indicate information about the battery status, boost
mode and error messages.
The charging state of the battery is indicated by the
3 green LEDs on the device as well as by the 3 green
LEDs on the battery.
See figure A on the graphics page and chapter
Geräte-
beschreibung
The charging progress of the battery is indicated by the
3 green LEDs on the device as well as by the 3 green
LEDs on the battery. The LEDs only light up when the
battery is correctly installed.
Changing accessories
To change accessories, see chapter Installing accesso-
ries
Vacuuming
1. Install the required accessories, see chapter Install-
ing accessories .
2. Switch on the device, depending on cleaning re-
quirements:
 Press the On/Off switch and keep it pressed dur-
ing operation.
or
 Turn the locking lever to switch the device directly
to continuous operation.
Illustration K
3. If necessary, press the Boost button to increase the
dust intake.
Illustration L
Note
When the device is switched off, the boost function is
automatically disabled.
The boost function can also be switched off by pressing
the Boost button again.
Ending operation
1. Switch off the device.
Release the On/Off switch or disable the locking le-
ver.
Note
To ensure an optimum suction performance, empty the
dust container and clean the air inlet filter after each
use.
Empty the dust container at the latest when the "MAX"
marking is reached.
2. Remove the suction pipe or accessory.
3. Empty the dust container into a waste container.
a Press the unlocking button.
The dust container flap opens.
b Empty the dust container.
Illustration M
4. To close the flap, push the dust container upwards
until it clicks into place.
Battery charging state
LED Duration of
lighting Meaning
1st LED flashes
green 1 s on / 1 s off Battery charged below
7.5 %
1st LED lights up
green continuously Battery charged below
40 %
1st and
2nd LEDs light
up green continuously Battery charged below
70 %
3 LEDs light up
green continuously Battery charged
above 70 %
3 LEDs flash
green 125 ms on /
125 ms off Battery fault, after 30 s
the signal goes out
While charging
LED Duration of
lighting Meaning
1st LED flashes
green 0.2 s from off
to on /
0.6 s on /
0.2 s from on
to off /
1 s off Battery charging, bat-
tery charged below
40 %
1st LED lights
up green
2nd LED flashes
green continuously
0.2 s from off
to on /
0.6 s on /
0.2 s from on
to off /
1 s off Battery charging, bat-
tery charged below
70 %
1st and
2nd LEDs light
up green
3rd LED flashes
green continuously
0.2 s from off
to on /
0.6 s on /
0.2 s from on
to off /
1 s off Battery charging, bat-
tery charged below
99 %
3 LEDs light up
green 2 min contin-
uous lighting,
then off Battery fully charged
Error message
LED Duration of
lighting Meaning
Suction duct
flashes red 125 ms on / 125
ms off Suction channel
clogged
Floor nozzle
LED flashes
red 125 ms on / 125
ms off Floor nozzle blocked
See also chapter Troubleshooting guide
Boost mode
LED Duration of
lighting Meaning
LED half ring
lights up green continuously Boost mode on
While charging
LED Duration of
lighting Meaning