Kärcher NT 48/1 TE, Original Instructions Manual

Page: 14 / 160

– 2
1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Drain hose
6 Suction hose
7 Suction head lock
8 Socket
9 Chassis
10 Dirt receptacle
11 Steering roller
12 Chassis handle
13 Floor nozzle
14 Suction tube
15 Suction support
16 Main switch
17 Suction head
18 Carrying handle
19 Cable hook
20 Bender
21 Cartridge filter
22 Fastening nut
23 Float
ATTENTION
Risk of damage! For dry vacuuming, the
cartridge filter must always be installed.
– When vacuuming fine dust, you may
also use an additional paper filter bag or
a membrane filter (special accessory).
Illustration
Illustration
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– If the appliance is used to vacuum wet
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Loosen the mounting nuts
 Remove the cartridge filter.
Illustration
 Insert the fastening nut and tighten it.
 Install the additional filter.
 Insert and lock the suction head.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
 Plug in the mains plug.
 Switch on the appliance at the main
switch.

DANGER
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
 Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch on the appliance at the main
switch.
Device elements
Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag
Installing an additional filter
Clip connection
Operation
Turning on the Appliance
Working with electrical power tools
14 EN