English
5.906-472.0 Rev. 00 (08/08)
7
After a certain amount of use, the cartridge filter is dirty and must
be cleaned or replaced as needed.
Î
Remove the suction head (see chapter 4.2).
Î
Unscrew the fastening nut (1).
Î
Remove the cartridge filter (2) toward the top.
Î
Install the cleaned or new cartridge filter in reverse order.
The seal (arrow) in the suction head can be replaced as follows if
needed.
Î
Remove the suction head (see chapter 4.2).
Î
Remove the seal from the suction head and insert new seal.
Remove the swimmer as follows to clean it.
Î
Remove the cartridge filter (see chapter 5.1).
Î
Remove the fastening screws (3).
Î
Remove the swimmer casing (1).
Î
Remove the swimmer (2) from the swimmer casing. The swim-
mer can now be cleaned or replaced if necessary.
Note
When installing the swimmer (2) make sure that the open side of
the swimmer is located inside the swimmer casing. If the swimmer
(2) is inserted the wrong way, it will lose its efficiency. This can
cause damages to the appliance.
1
Swimmer casing
2
Float
3
Fastening screws (2x), swimmer casing
5
Basic settings and service procedures
5.1
Remove cartridge filter
5.2
Replace seal
5.3
Remove the swimmer
