Kärcher KM 70/30 C Bp Adv, Manual

Page: 10 / 147

-
3
 Remove the battery.
 Dispose of the used battery according
to the local provisions.
Figure 3, see cover page
 Loosen both the star grips.
 Pull the pushing handle backward and
tilt it to the desired position.
 Press the pushing handle forward and
lock it in.
 Tighten the star handles.
Figure 4, see cover page
1 OFF - Appliance is switched off.
2 Sweep.
3 Sweep suction (only Adv. model).
몇 CAUTION
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
The drive belts of the side brushes can slip
down. Tilt up the side brushes only when
the appliance is switched off.
NOTICE
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
NOTICE
During operation, the waste container
should be emptied at regular intervals.
NOTICE
Also lower side brush when cleaning along
edges.
 Tilt the side brushed upward or down-
ward depending on the task.
NOTICE
The dust raised by the side brush is not
vacuumed up. Use the side brush only for
sweeping at the edge.
 Set the programme switch to sweep or
sweep suction.

Move the appliance over the surface to
be swept.
Figure 5, see cover page
 Lift, adjust and lower the lever for the
contact pressure of the sweeping roller.
+ Increase contact pressure.
– Reduce contact pressure.

Adjust the pressure by turning the turn-
ing handle for the contact pressure of
the side brushes.
+ Increase contact pressure.
– Reduce contact pressure.
NOTICE
A very high contact pressure means in-
creased power consumption and hence
lesser usage time.
Figure 6, see cover page
 Slightly press the pushing handle
downward so that the appliance lifts up
slightly towards the front.
 Move the appliance with the raised up-
per part over the dirt.
 Now lower the appliance again.
The battery display shows the charging sta-
tus of the battery during operations:
몇
WARNING
Risk of injury on account of rotating roller
brush.
 Before removing the waste container
please turn the programme selection to
"OFF" and wait until the roller brush
comes to a halt.
NOTICE
Dust generation. As far as possible, shake
off the filter and empty the waste container
outdoors.
 Turn the program selection switch to
"OFF".
 Only Adv. model: Pull the handle of the
filter shake-off many times and releaes
it.
 Only Adv. model: Tilt the dust suction
upward.
 Pull the waste container upward at the
handle and remove it from the appli-
ance.
Figure 7, see cover page
 Dispose off the waste according to local
regulations.
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
 Park the sweeper on an even surface.
 Set lever for roller brush contact pres-
sure completely to “–”(all the way back).
 Lock the sweeper to ensure that it does
not roll off.
 Clean the inside and outside of the
sweeper.
 Park the machine in a safe and dry
place.
 Disconnect battery.
 Charge battery and recharge it approx.
every 2 months.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Turn the program selection switch to
"OFF".

Lift the appliance at the carrying han-
dles when you want to transport it.
 Secure the wheels of the machine with
wheel chocks.
 Secure the machine with tensioning
straps or cables.

When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
 DANGER
Risk of injury!
 Prior to performing any tasks on the de-
vice, turn the programme selector
switch to "OFF“and disconnect the ca-
ble from the negative terminal of the
battery.
Short circuit hazard!

Do not clean the device with a water
stream.
몇 CAUTION
 Do not use aggressive and abrasive de-
tergents.
몇
WARNING
Risk of injury!
 Wear dust mask and protective gog-
gles.
 Blow through machine with com-
pressed air.
 Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.

Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Daily maintenance:

Check the sweeping roller and the side
brush for wear and wrapped belts.

Check function of all operator control el-
ements.
Weekly maintenance:
 Clean both the foam filters under flow-
ing water.
 Only Adv. model: Check flat-fold filter.
 Check moving parts for freedom of
movement.
Start up
Adjust the pushing handle
Operation
Programme selection
Sweeping mode
KM
70
/30
C
Bp
KM
70
/30
C
Bp
Pack
KM
70
/30
C
Bp
Adv.
KM
70/30 C Bp Pack Adv:
Dry floor Sweep Sweep suc-
tion
Wet floor Sweep Sweep
Adjust the brush contact pressure
Collect dirt
Battery display
full glows green
30% capacity re-
maining glows yel-
low
10% capacity re-
maining blinks red
Protection against
total discharge; the
appliance is
switched off glows red
Emptying waste container
Shutdown
Transport
Storage
Care and maintenance
Cleaning the inside of the machine
External cleaning of the appliance
Maintenance intervals
10 EN