Operating instructions
KM 100/100 R B / KM 100/100 R LPG
English
38
Replace the sweep roller
—
Replacing it is necessary when
the sweeping effect visibly
deteriorates due to wear of the
bristles.
!
Stand sweeper on a flat surface
!
Raise the sweep roller
!
Turn ignition key to "0" and
remove it
!
Secure the machine against
rolling away using a wedge
!
Remove the debris container
from both sides of the unit
!
Unscrew front screw of right side
panellint
!
Unscrew rear screws of right side
panelling
!
Unscrew screws
!
Screw out screw at main brush
bracket
!
Remove bracket of main brush
pivoting arm
!
Remove lifting rod from peg
!
Lift off cover and remove main
brush
!
Push main brush into main brush
box and position it onto the
driving peg
Note:
Pay attention to the position of the
bristle set when installing the new
main brush!
!
Mount main brush cover
!
Slide lifting linkage onto peg
!
Slide main brush bracket onto
peg
!
Retighten screw at the main
brush bracket
!
Fit and tighten fastening screws
of main brush cover
!
Screw on side panelling
!
Insert the swept material
container
Check sweeping pattern of
the main brush
!
Raise the sweep roller
!
Raise the side broom
!
Drive the sweeper on a flat and
smooth floor noticeably covered
with dust or chalk
!
Lower the main brush and rotate
it briefly
!
Raise the sweep roller
!
Depress pedal to raise the
coarse-dirt flap and keep it
depressed
!
Back the machine away
The form of the sweeping pattern
forms a regular rectangle, that is
between 50 - 70 mm wide.
Note:
—
Due to the floating suspension of
the main brush The sweeping
pattern automatically adapts itself
to wear of the bristles.
—
The main brush must be replaced
when the bristles are too worn.
