Operating instructions
KM 100/100 R B / KM 100/100 R LPG
English
37
Check and top up the
hydraulic oil level
Note:
The sweeper is provided with two
hydraulic circuits:
1. Sweeping hydraulics circuit
!
Check of fill level in the storage
reservoir
!
Open unit cover, engage stay bar
The oil level must be between the
"MIN" and "MAX" marks.
!
Open the cap to refill
!
Fill in hydraulic oil
!
Close reservoir
For oil grade see: Technical data
2. Axle drive circuit
!
Check of fill level in
compensating reservoir
Warning!
This check may be performed only
when the engine is cold.
!
Open unit cover, engage stay bar
!
Remove the reservoir cap
—
In the reservoir its bottom may
just be covered with oil
!
If necessary, carefully replenish
with oil
!
Close reservoir
For oil grade see: Technical data
Checking the vacuum
system
—
Adding a sweeping system is
with the aid of a vacuum system.
Note:
Always first add the main brush,
since otherwise the side brush does
not rotatet.
—
The vacuum canister for lowering
the side brush is to be checked
for leaks and proper connection
of the hose if the side brush
cannot be lowered; attach the
hose, if necessary.
Hose connection to vacuum canister
of side brush lowering
—
The vacuum system is leaking if
the side brush can still not be
lowered. In this case after-sales
service must be contacted.
Check the side brush
!
Raise the side broom
!
Drive sweeper over a flat, smooth
surface covered with a clear layer
of dust
!
Lower side brush and start up
!
Raise the side broom
!
Drive aside backwards
!
Check the sweep mirror
Width of sweeping range should be
between 40 - 50 mm
Note:
—
The sweeping pattern is
automatically adjusted to wear of
the brushes due to the floating
suspension of the side brush.
—
Replace the side brush when the
bristles are too worn.
Replacing side brush
!
Unscrew fastening screws
(3 pieces) at the underside
!
Slip side brush on carrier and
screw it tight
Check the sweep roller
!
Stand sweeper on a flat surface
!
Raise the sweep roller
!
Turn ignition key to "0" and
remove it
!
Secure the machine against
rolling away using a wedge
!
Remove the debris container
from both sides of the unit
!
Remove tapes and string from
the sweep roller
