Kärcher KM 100/100 R B, User Manual

Page: 14 / 21

Operating instructions KM 100/100 R / KM 100/100 R P English
29
! Slide the new main brush into the
main brush box and slip it onto
the drive peg
Notes:
— Pay attention to the position of
the bristle set when installing the
new main brush!
— The bowden cable is to be
adjusted so that the main brush
is raised approx.
1 0 mm from the
floor.
!
Follow the instructions in reverse
to mount the main brush rocker
arm
!
Screw on side panelling
!
Insert the swept material
container
Adjusting and replacing
sealing strips
! Stand sweeper on a flat surface
! Raise the sweep roller
! Turn key switch to "0" and
remove key
! Secure the machine against
rolling away using a wedge
! Remove the debris container
from both sides of the unit
! Screw off side panelling on both
sides
! Unscrew front screw of side
panelling
! Unscrew rear screws of side
panelling
Front sealing strip
! Slightly loosen fastening nut at
the front sealing strip, unscrew it
to replace it
! Screw on new sealing strip but
do not yet tighten nuts
! Align the sealing strip
! Set the sealing strip’s clearance
to the floor so that it bends
backwards with a lag of
35 - 40 mm
!
Tighten nuts
Rear sealing strip
! The floor clearance of the sealing
strip is set so that it bends
backward with a lag of
5 -
1 0 mm
! Replace if worn
! Dismantle the sweeping drum
! Unscrew fastening nuts of the
rear sealing strip
!
Screw on new sealing strip
Side sealing strips
! Slightly loosen fastening nuts of
the side sealing strip, unscrew
them to replace it
! Screw on new sealing strip but
do not yet tighten nuts
! In order to set the clearance to
the floor slide in the 1 - 2 mm
spacer
! Align the sealing strip
! Tighten nuts
! Screw on side panelling
! Insert the swept material
container