Kärcher HDS 551 C Eco, Instruction Manual

Page: 28 / 417

28
English
Î Place supplied hand crank into hose
drum shaft.
Î
Before unwinding the high pressure
hose loose hose windings must be tight-
ened: Turning of the hand crank clock-
wise (direction of the arrow).
몇
Warning
Always unwind high pressure hose com-
pletely
For connection values refer to technical
specifications
Figure 1 - Pos. 9
Î Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note
The supply hose is not included.
Observe regulations of water supplier. Ac-
cording to DIN 1988 it is not allowed to con-
nect the device directly to the public water
supply. A brief connection through a pipe in-
terruptor (Order Nr. 6.412-578) is admissi-
ble. The high pressure cleaner is to be
separated from the water supply after use.
If you want to suck in water from an external
vessel, the following modification is neces-
sary:
Figure 3
Î
Remove liquid softener container up-
ward
Î Dismantle upper supply hose to to the
swimmer tank and lead it to pump head.
Figure 4
Î Unfasten water connection at pump
head and turn sideways.
Î Connect supply hose at pump head.
Î Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the wa-
ter connection point.
– Max. suck height: 0.5 m
Until the pump sucked in water, you should:
Î Turn the pressure and quantity regula-
tion to MAX.
Î Close the dosing valve for the detergent.

Danger
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, explo-
sive and poisonous.
For connection values, see technical data
and type plate.
몇
Warning
The highest allowed net impedance at the
electrical connection point (refer to technical
data) is not to be exceeded.
Main Plug Assembly:
– Have Kärcher customer service or an-
other authorized electrical professional
install the main plug.
Î Set the appliance switch to "0".
Î Plug in the main plug.
몇
Warning
Check direction of rotation of the engine at
every socket change.
– With correct direction of rotation a strong
airflow can be felt out of the exhaust
opening of the burner.
– For incorrect direction of rotation refer to
malfuntion "Burner is not igniting".
Î If you use an extension conduit it should
be unrolled all the time and possess a
sufficient cross section (10 m = min. 1.5
mm
2
; 30 m = min. 2.5 mm
2
).
Device with hose drum
Water connection
HDS 551 C Eco only
suck in water from vessel
Only HDS 558.../601.../698.../798...
Power connection
HDS 698.../798...only