![background image](http://html2.mh-extra.com/html/karcher/hds-4-0-32-pe-cage/hds-4-0-32-pe-cage_operators-manual_4180846011.webp)
9.800-103.0 • REV. 1/07
11
PRESSURE
W
ASHER
OPERA
TOR’S MANU
AL
SHUTTINg DOWN AND CLEAN-UP
STORAgE
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure
hose.
3. Turn on the machine for a few seconds, until re-
maining water exits. Turn engine off immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become
kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
When the pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through the
spark plug hole, pull the starter grip several times
and replace the plug. Then pull the starter grip
slowly
until you feel increased pressure which indicates
the piston is on its compression stroke and leave
it in that position. This closes both the intake and
exhaust valves to prevent rusting of cylinder.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open flame
or sparks.
NOTE:
The use of a fuel additive, such
as STA-BIL
®
, or an equivalent, will minimize the
formulation of fuel deposits during storage. Such
additives may be added to the gasoline in the fuel
tank of the engine, or to the gasoline in a storage
container.
After Extended Storage
CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses,
spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric conditions
may develop which will cause an icing condition in the
carburetor. If this develops, the engine may run rough,
lose power and may stall. This temporary condition can
be overcome by deflecting some of the hot air from the
engine over the carburetor area.
NOTE:
Refer to the
engine manufacturer's manual for service and mainte-
nance of the engine.
STEP 1:
Remove detergent suction
tube from container and insert into
one gallon of fresh water. Open de-
tergent metering valve. Pull trigger
on spray gun and siphon water for
one minute. Close detergent valve.
STEP 2:
Turn off the engine.
STEP 3:
Turn off the water
supply.
STEP 5:
Disconnect the garden
hose from the water inlet on the
machine.
STEP 6:
Disconnect the high
pressure hose from high pres-
sure outlet.
STEP 7:
Engage
t h e s p r a y g u n
safety lock.
STEP 4:
Press
trigger to release
water pressure.
On-Off
Switch
Safety
Latch
Summary of Contents for HDS 4.0/32 Pe Cage
Page 2: ......
Page 44: ...Form 9 800 103 0 Revised 1 07 Printed in U S A...