background image

– 2

High-pressure jets can be dan-
gerous if improperly used. The 

jet may not be directed at persons, animals, 
live electrical equipment or at the appliance 
itself.
 According to applicable regula-
tions, the appliance must never be 
used on the drinking water net 
without a system separator. A suit-
able system separator by KÄRCHER or al-
ternatively a system separator according to 
EN 12729 type BA must be used. 
Water that was flowing through a system 
separator is considered non-drinkable.

CAUTION

Always connect the system separator to 
the water supply, never directly to the appli-
ance!

Use this high pressure cleaner exclusively 
for
– Cleaning using low pressure jet and de-

tergent (for e.g. for cleaning machines, 
cars, buildings, tools),

– For cleaning using high pressure jet 

without detergent (for e.g. for cleaning 
facades, terraces, garden appliances).

For stubborn dirt, we recommend the use of 
the dirt blaster as a special accessory.
HD...Plus includes a dirt remover as part of 
standard delivery.

Quality requirements for water:

ATTENTION

Only clean water may be used as high 
pressure medium. Impurities will lead to in-
creased wear and tear or formation of de-
posits in the appliance.
If recycled water is used, the following limit 
values must not be exceeded.

Safety devices serve for the protection of 
the user and must not be put out of opera-
tion or bypassed with respect to their func-
tion.

While reducing the water supply/quantity 
regulation at the pump head, the overflow 
valve opens and part of the water flows 
back to the pump suck side.
If the pulling lever on the trigger gun is re-
leased the pressure switch turns off the 
pump, the high-pressure jet is stopped. If 
the pulling lever is pulled the pump is 
turned on again.
When the maximum operating over pres-
sure is exceeded, the overlow valve opens 
and the water flows back to the pump inlet. 
The overflow valve and pressure switch are 
set and sealed at the factory. Setting only 
by customer service.

Symbols on the machine

Proper use

pH value

6,5...9,5

electrical conductivity *

Conductivity 
fresh water 
+1200 µS/cm

settleable solids **

< 0,5 mg/l

total suspended solids *** < 50 mg/l
Hydrocarbons

< 20 mg/l

Chloride

< 300 mg/l

Sulphate

< 240 mg/l

Calcium

< 200 mg/l

Total hardness

< 28 °dH
< 50 °TH
< 500 ppm 
(mg CaCO

3

/l)

Iron

< 0,5 mg/l

Manganese

< 0,05 mg/l

Copper

< 2 mg/l

Active chloride

< 0,3 mg/l

free of bad odours
* Maximum total 2000 µS/cm
** Test volume 1 l, settling time 30 min
*** no abrasive substances

Safety Devices

Overflow valve with pressure switch

4

EN

Summary of Contents for HD 7/11-4 M













Reviews: