– 4
Figure 2, see cover page
Adjust the push handle on the appli-
ance.
Fasten the push handle with a mush-
room head bolt and washer and nut.
Repeat process on the opposite side.
Slide the wheel onto the axle.
Slide adjusting collar onto the shaft and
tighten the screw.
Repeat process on the opposite side.
Note:
The EASY!Lock system joins com-
ponents with a quick-fasten thread solidly
and securely with just one turn.
Join the spray lance with the trigger gun
and tighten until hand-tight
(EASY!Lock).
Insert the high pressure nozzle onto the
spray lance.
Install union nut and hand-tighten it
(EASY!Lock).
Join the high-pressure hose with trigger
gun and high-pressure connection of
the appliance and tighten until hand-
tight (EASY!Lock).
Figure 3, see cover page
Fasten the storage compartment to the
push handle.
Figure 4, see cover page
Secure both hose switches.
몇
WARNING
Observe regulations of water supplier.
For connection values refer to technical
specifications.
Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4“) to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note:
The supply hose is not included.
Open the water supply.
DANGER
Health hazard!
Never suck water from a drinking water
container.
Risk of explosion, risk of poisoning!
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol or oil. The
spray mist of solvents is highly inflamma-
ble, explosive and poisonous.
ATTENTION
Risk of damage! Do not suction unfiltered
water.
Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.
Remove air from appliance before oper-
ation.
Open the water supply.
Note:
If a suction hose with a check valve or filter
is used, the hose must be filled with water.
Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
Switch off the appliance and fit the noz-
zle again.
Attaching frame parts
Attaching the Accessories
Only HD 8/23 G:
2.
1.
Water connection
Suck in water from vessel
Dearating the appliance
16
EN
Summary of Contents for HD 6/15 G
