English
11
Detergent admixture: 3 = high, 2 =
medium, 1 = low
4
Suction hose
5
EASY!Force high-pressure gun
1. Unscrew container.
2. Insert the desired aperture into the
suction hose.
3. Fill detergent in the container.
4. Screw the container onto the foam
nozzle.
5. Remove the spray lance from the
high-pressure gun.
6. Attach the foam nozzle to the high-
pressure gun and tighten by hand.
7. Start up the high-pressure cleaner.
Recommended cleaning method
1. Spray the detergent sparingly on the
dry surface and let it work for a while
(do not let it dry).
2. Rinse off the loosened dirt with the
high-pressure jet.
Rinsing the foam lance
The foam lance must be rinsed after
use to avoid detergent deposits.
1. Unscrew container.
2. Return the remainder of the deter-
gent to the delivery packaging.
3. Fill container with clear water.
4. Screw the container onto the foam
nozzle.
5. Operate the foam nozzle for approx.
1 minute to rinse off any remaining
detergent.
6. Empty the container.
Interrupting operation
1. Close the high-pressure gun; the de-
vice switches off.
2. Secure the high-pressure gun by
pushing the safety latch forwards.
Note
When switching off the device, the wa-
ter pressure is lowered by approx.
70%. This reduces the actuation force
of the high-pressure gun and increases
the service life of the device.
Continuing operation
1. Unlock the high-pressure gun by
pushing the safety latch backwards.
2. Open the high-pressure gun; the de-
vice switches on again.
Finishing operation
1. Close the water inlet.
2. Open the high-pressure gun.
3. Turn the power switch to "I" and let
the device run for 5 to 10 seconds.
4. Close the high-pressure gun.
5. Turn the power switch to “0/OFF”.
6. Pull the mains plug out of the socket
only when your hands are dry.
7. Remove the water inlet.
8. Open the high-pressure gun until
the device is completely depressur-
ized.
9. Secure the high-pressure gun by
pushing the safety latch forwards.
Keep the device safe
1. Place the spray lance with the high-
pressure gun on the spray lance
holders.
2. Wind up the power cable around the
cable/hose switch.
3. Wind the high-pressure hose; hang
over the cable/hose switch.
Frost protection
ATTENTION
Frost destroys the device which has
not been completely drained of wa-
ter.
Store the device in a frost-free location.
If it is not possible to store free from
frost:
1. Drain the water.
2. Pump commonly available anti-
freeze through the device.
