![background image](http://html1.mh-extra.com/html/karcher/chariot-2-ivacuum-24-130-a-h/chariot-2-ivacuum-24-130-a-h_operators-manual_3664468039.webp)
39
Maintenance
To Repair or Replace Vacuum Motor
1. Remove four (4) screws from top of control panel.
2. Tip control panel back from console to expose
vacuum motor wires.
3. Disconnect electrical connector from the vacuum
motor.
4. Replace one screw to secure control panel to
console.
5. Open console.
6. Remove the two (2) nuts from vac motor bracket,
as shown below.
7. Remove three (3) screws that secure vacuum
motor assembly in place. Remove vacuum motor
assembly, as shown below.
8. Remove move three (3) screws that secure
vacuum motor. Replace motor.
9. Reverse steps to install.
NOTE: If vacuum motor is not mounted as shown,
vacuum may not seal properly, resulting in poor
performance.
VACUUM MOTOR
BRACKET
VACUUM ASSEMBLY
MOUNTING SCREWS (3)
1.18
VACUUM MOUNTING
SCREWS (3)
3
8
[9.5mm]
Vacuum Motor Carbon Brushes
Carbon
Brushes
End Cap
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Inportant:
These brushes wear quicker as the length shortens due to
increased heat. Spring inside brush housing will damage
motor if brushes are allowed to wear away completely.
both carbon brushes when either is less tan 3/8" (9.5mm)
long.
8.644-676.0 Operator’s Manual - iVac 24 ATV
Summary of Contents for Chariot 2 iVACUUM 24 130 A/H
Page 14: ...14 Operations Drive Controls 1 2 3 4 5 6 7 8 9 10 8 644 676 0 Operator s Manual iVac 24 ATV ...
Page 46: ...46 Suggested Spare Parts 8 644 676 0 Operator s Manual iVac 24 ATV ...
Page 90: ...44 Sugerido De Piezas Sueltas 8 644 676 0 Operator s Manual iVac 24 ATV ...
Page 91: ...45 Notes 8 644 676 0 Operator s Manual iVac 24 ATV ...