8-zone Telephone Alarm System
-
4
-
Picture 4
5.Program Of Main Unit
5.1Program Precautions
①
The phone should be standard DTMF
(
double tone
multi frequency
).
and the power of telephone is provided by AC power, so please pick
receiver up instead of free hand when programming.
②
Main unit only can be programmed in disarm state, and it will delete
all alarm information and power lower information after entering into
setup state, therefore, before entering setup state, please check
whether to keep records firstly or not. After entering setup state,
please arm the main unit in time to avoid missing alarm message.
③
After entering into setup state, the telephone will cut with outside line,
and there should be no any dialing tone.
④
If there are no indicate sound when pressing telephone keyboard,
please check to see weather the lines are correctly connected, if the
connection is correct, please try another telephone set.
⑤
Main unit will make a short “Du” sound every time pressing keyboard
on telephone, therefore, during setting, you can adjust wheather the
operation is valid or not according to the sound made by main unit.
Four short “Di” sound ------The operation is effective.
Two long “Di” sound ------- The operation is ineffective.
⑥
Press “*” key to delete if you press wrong information (except when
entering telephone numbers).
⑦
Delete Directive: If you delete anything, there should be an indication
if the operation is successful, that is all zone lights are on at the same
time, and then be off one by one, then the main unit will make four
short “Di” sound.
⑧
If there are no any operations for 60 seconds after entering setting
state, the system will exit from setting state automatically.
⑨
You can exit setting state by pressing “SET” button at the back of main
unit, and the “SET” indicator light will be off, which means it has
exited from setting state.
SET
PHONE LINE
220V AC
Telephone
Line
