19
Remove the outer flange and worn blade disc. ( carefully)
Place a new blade disc onto the saw arbor shaft, and sure the disc rotation direction must be clockwise.
Place the outer flange and lock nut onto the saw arbor shaft and tighten the blade with 12 & 30mm spanners.
Re-install the blade guards.
Check the space between the blade and blade guards. Keep the blade free from the blade guards. And keep the water tube free from
the blade disc.
Tighten 3 wing screws on the blade guards, and always have the blade guards installed during operation.
OPERATION
90° Cutting
Fill the tank with water and keep the water pump sunk into water.
Check the angle of saw blade with the work table by a combination square, if the saw blade in not 90O with the work table, loosen the
two hex head screws (F) on support bracket to adjust.
Fix the workpiece on table, the end of workpiece is against the guide bracket.
Plug the power cables for main machine to power supply.
Turn the switch on, check the water supply, if necessary adjust the water-cock on the upper of blade guard. Make sure the water is
sprayed on the two sides of saw blade.
Pull the head handle(G) backward to workpiece for cutting.
Bevel cutting
The head assembly can be tilted from 0O to 45O for bevel cutting.
Loosen two ratchet levers(H) on support brackets, turn the head to desired angle. Then re-tighten two ratchet levers.
Then performance the cutting as normal cut.
Caution:
Do not over force the workpiece, otherwise may cause the blade disc
overheat.
When cut a long or thick workpiece, the blade disc must backward to
avoid overheat more-times.
When cutting, must keep the workpiece stably and avoid sliding.
Risk of kickback
Do not attempt to stop the saw blade by pushing the work-piece against
its side.
Never cut several work-pieces at the same time and also no bundles
containing several individual pieces.
Risk of personal injury
