20
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
1
1
1
1
1
1
1
1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
■
Programming of decorative stitches (EDIT)
The machine can be memorized up to 99 kinds of the process (LED display
①，
01~99 ),
including 5 kinds of the process 01~05 which already saved to the machine when you
start sewing. One process can be programmed up to 64 patterns (LED display
②
,
01~64 ).
＊
Programming procedure of new pattern is as follows.
1. Turn off the lamp of (AUTO) key
⑤
by pressing (AUTO) key
⑤
.
2. Set the EDIT mode by pressing the (EDIT) key
⑥
.
3. Display the desired process number to be entered new pattern to LED display
①
by
using (SETTING) key
③
. (In this case, LED display
②
shows 01 automatically)
4. Select the one desired pattern from 1~3 of FEED PATTERN
⑩
.
Then, flashing the lamp by pressing the key once.
5. Enter this pattern by pressing the (WRITE) key
⑧
once.
(After that, the flashing lamp turns ON).
6. Select the one desired pattern number.
Then, display it to LED display
②
by using the SETTING key
④
.
7. Select the one desired pattern from 7 kinds of FEED PATTERN
⑩
and FLOWER
PATTERN
⑨
. Then, flashing the correspondent lamp by pressing the key once.
8. Enter this pattern by pressing the (WRITE) key
⑧
once.
(After that, the flashing lamp turns ON).
9. Then, the same sequence from the procedure 6, 7, 8 should be performed, to make a
new sewing pattern.
10. After entering all desired patterns, keeping to press the (WRITE) key
⑧
over 2
seconds. Then, ensure one-time flashing of LED display
①
and
②
.
The programming of a new sewing pattern is completed.
11. Turn on the lamp of the bottom dead point
⑫
, by hand-turning of the pulley.
12. After turning on the lamp by pressing of the (AUTO) key
⑤
, start the sewing.
< Note >
The 5 kinds of basic pattern which already saved ( 01~05 ) can easily be replaced to the
new pattern by using the EDIT function. Therefore, when programming of new
pattern, please start to use the bigger process number than 06, in order to avoid miss
programming.
< Note >
When beginning with pattern, start with FEED not with FLOWER.
After entering a flower pattern, be sure to follow by entering feed pattern.
Flower pattern must always be followed by feed pattern.
