kansai MAC100, Instruction

Page: 19 / 25

16
Ｍ Ｍ Ｍ Ｍ
Ｍ Ｍ Ｍ Ｍ
Ａ Ａ Ａ Ａ
Ａ Ａ Ａ Ａ
Ｃ Ｃ Ｃ Ｃ
Ｃ Ｃ Ｃ Ｃ
1 1 1 1
1 1 1 1
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
11 11 11 11----2222 Mounting of position transmitter Mounting of position transmitter Mounting of position transmitter Mounting of position transmitter
1. Mount the position transmitter (A) to the
pulley.
Then, temporary-fasten the screw (B).
2. Set the position-bar (C) to the guide groove of
the position transmitter (A).
Then, fasten the nut (D).
3. Turn on the ON-OFF switch.
4. Confirm whether the lamp of the upper dead
point and the bottom dead point (refer to 11-4.
fig. 11, 12) on the operation panel turns on at
the needle upper dead point and the needle
bottom dead point or not, by hand-turning of the
hand wheel.
■
Adjusting of the needle stopping position
1. Loosen the screw (B) slightly after taking off the
cover (A).
2. Adjusting of the needle upper dead point;
Firstly, move to keep the needle position at the
upper dead point. Then, move to adjust the
detector disc of the upper dead point (C: inner
disc-black color), until turning on the lamp of
the upper dead point (refer to 11-4. fig. 11) on
the operation panel. After that, fasten the
screw (B).
3. Adjusting of the needle bottom dead point;
Move to keep the needle position at the bottom dead point. Then, move to adjust the
detector disc of the bottom dead point (D: outer disc-red color), until turning on the
lamp of the bottom dead point (refer to 11-4. fig. 12) on the operation panel.
In this case, no need to loosen the screw (B).
11 11 11 11----3333 Connecting of earth terminal Connecting of earth terminal Connecting of earth terminal Connecting of earth terminal
Connect the earth cord (C) of the position
transmitter (B) to the machine head (A) by the bolt
(D).
< Note >
Make sure to connect the earth cord to the machine
head. If not, it may cause to make a miss-operation.