2. Unscrew and remove the inlet and outlet nozzles and threaded lock nuts on either end.
3. Remove the sensor head by carefully pulling it upwards, disconnecting it from the monitor.
4. Replace the sensor head.
5. Re-insert the nozzles and tighten using the lock-nuts on either end and ensure there is a tight
fit against the sensor head.
6. Replace the lid and tighten the four lid screws.
7.2.3. Removing the Monitor
1. Undo the four lid screws at
each corner using a flat
headed screw driver and
remove the lid.
2. Loosen the lock nuts on either
end of the sensor head.
3. Depress the blue plastic clips
on either side of the monitor
unit and then lift the monitor
up.
4. This will expose the
rechargeable battery and also allow the mounting screws holding the blue battery cover to be
accessed.
5. Carefully disconnect the monitor from the sensor head and remove from the enclosure.
6. Reverse the process to reconnect the monitor back onto the battery cover.
8.
Troubleshooting
Lock Nut
Lock Nut
Page | 30
Kanomax Gasmaster User Guide
MRK-D-0002 V3
