KanexPro HD-VTSC72-4K, User Manual

Page: 65 / 67

65 / 67
Click Reset to restore all network setting to be factory default, as DHCP enable, and TCP Auto mode.
Other
Factory Reset Button
The Switcher can be set to factory default by the front panel button. The method is
1)
Press and hold the input 5 button on the front panel
2) Press the “Standby” button to wake the unit from standby mode.
3) You’ll see all the front panel button LEDs blink to indicate the unit is being set to factory default.
F/W Update Guide
The Switcher can be updated through a USB drive as follows.
1) Copy the updating file “MERGE.bin” to the root directory of the USB drive.
2) Connect the USB drive to the USB port on the rear of the device.
Attention: The USB port can only support maximum 500ma. Please use a small power U-­‐disk as
upgrading USB drive.
3) Connect a HDMI display to the switcher.
4) Turn on the switcher. The display device displays the HDMI output signal after normal boot of
the device.
5) Press and hold the INPUTS 1 button for more than five seconds, "System is upgrading…"is
displayed in the display device, at the same time, all buttons indicators on the front panel
blink.
Attention: The unit can’t be power-­‐off until the upgrading progress is finished. Or, the unit
firmware will be corrupted.
6) After updating, “Upgrading is successful, system will reboot” is displayed in the display device.
After seconds, the unit will reboot.
7) The unit reboots automatically.
8) Till now, the whole upgrading progress is finished.
Electrical Parameters
Specifications
Supported Formats