Kane KANE251, Manual

Page: 24 / 40

Page 24
12. ANALYSER PROBLEM SOLVING
If any problems are not solved with these solutions, contact us or an
authorised repair center.
Fault symptom Causes / Solutions

Oxygen too high
 CO
2
too low

Air leaking into probe, tubing, water
trap, connectors or internal to analyser.

CO reading (- - - -)

Analyser was stored in a cold
environment and is not at normal
working temperature.

CO sensor needs replacing.
 Pump is switched off

Batteries not holding
charge

Analyser not running on
mains adapter.

Batteries exhausted.

AC charger not giving correct output.
 Fuse blown in charger plug.

Analyser does not
respond to flue gas

Particle filter blocked.
 Probe or tubing blocked.

Pump not working or damaged with
contaminants.

Net temperature or
Efficiency calculation
incorrect.

Ambient temperature set wrong during
Automatic Calibration.

Flue temperature
readings erratic

Temperature plug reversed in socket.
 Faulty connection or break in cable or
plug.

T flue or T nett displays
-(-OC-)

Probe not connected.

X-Air, EFF display (-O>-)

CO
2
reading is below 2%.

Analyser just continually
beeps

Turn dial back to MENU and press
ENTER