K&S KS 3000, Instruction Manual

Page: 17 / 30

16
11. BEFORE STARTING
11.1. CHECK THE FUEL LEVEL
1. Please wear protective gloves to avoid getting gasoline on the skin.
2. Remove the fuel tank cap and check the fuel level
3. Add fuel to the filter level if necessary
4. Screw the fuel tank cap back tightly
pic 8
pic 9
11.2. CHECK THE OIL LEVEL
1. Please wear protective gloves to avoid getting oil on the skin.
2. Unscrew the oil level gage and clean it with clean cloth.
3. Put the oil gage back without screwing it.
4. Take the oil level gage out and check the oil level
according to the mark on a gage.
5. Add oil if it’s level is below the mark on a gage.
6. Screw the oil gage back.
The recommended fuel type for this generator is A-92 type
petroleum. The use of other fuels could cause engine damage.
! !
IMPORTANT!
! !
IMPORTANT!
If the generator has not been used for a long time, try charging the
battery with the battery charger (not included).
Fuel tank cap
FILL TO
HERE
12. ENGINE START
Before starting the engine please make sure that power of instruments or
electric consumers complies to the capacities of the generator. It is forbidden
to exceed its nominal capacity. Do not connect devices before starting the
engine. In power supply mode within range from nominal till maximum
power, the generator may operate not more than 30 minutes.
Before turning the generator on, verify that the connected devices are in working
order. If the connected device suddenly stops running – turn the power off by means
of an emergency switch, disconnect the device and check it.
Warning! Do not let the simultaneous connection of two or more devices.
Start of many devices requires large power capacity. Devices are to be
connected in turns, according to its maximum allowed power. Do not
connect the consumers in first 3 minutes after the generator start.
! !
ATTENTION - DANGER!
! !
ATTENTION - DANGER!