7.2
Sparking Plug
Take off the cap of
sparkling plug.
Dust the tray of sparkling
plug.
Take out sparkling plug by
wrench.
Inspect the electrode and
replace it if the electrode
and the nonconductor are
burnt in a improper way.
A new one should be
installed if sparkling plug is
apparently burnt or the
nonconductor is broken.
Inspect the distance
between the electrodes.
The normal distance is 0.61-
0.71mm. You must make it
to the right place carefully if
the distance is not proper.
Please drive the screw by
hand if installing sparkling
plug to avoid sliding-
filament.
After the above-mentioned
step, you can drive fasten it
½ circle (for new sparkling
plug) or ¼ - 1/8 circle (for
used sparkling plug) by the
special wrench for sparkling
plug.
7.3
Air cleaner
Routine cleaning is necessary
because dust will be left in air
cleaner during the use. Frequent
cleaning should be conducted if
driving in the dusty area.
7.3.1
Cleaning of air cleaner
Take off the plastic
protecting jacket.
Take off the cover of Air
cleaner.
Take the filter out of
the air cleaner.
You can clean the
cleaner in the
dissolvent of
inflammable and high
flash point. Then soak
the filter in the clean
engine oil for 5 minutes
and squeeze out the
rest engine oil.
Dust the empty air filter
box, the cover and the
entrance and place the
dry filter into air filter
box.
7.4
Brake Staff
Dish Brake is adopted in the
vehicle and you should inspect
the free path of brake pedal,
the joints of the braking system
and the leakage.
Routine inspection is necessary
for the braking disks to make
sure that it doesn’t reach the
extreme points.
ATTENTION:
you should tighten sparkling plug
and otherwise it will cause the damage of
engine as a result of overheating.
ATTENTION:
You should not tighten it
to squeeze out the rest engine oil and
the otherwise will damage the filter.
Summary of Contents for 150GKA-2 Series
Page 1: ...Important Safety Warning...
