MAXICAL
®
I
I
I
5511-229 GB/98.06/Rev. B1
45
The program can also be used to print the label - which can be
seen in the window to the right of MAXICAL
®
III’s front foil. The
printer used for this purpose must be connected to the computer’s
parallel port, LTP1. The printer must be suitable for Windows and
for printing small labels.
Kamstrup A/S recommend OKI 610ex, OKI 410ex or HP4 laser
printer.
The original labels for MAXICAL
®
III can be ordered from
Kamstrup A/S - product No. 2008-259.
11.2 Installing the Software
Use Windows File Manager to check that there is at least 10 MB
free space on the hard disk.
Close any other Windows programs that may be running, before
proceeding to install.
Start Windows Program Manager, select File and click with the
left hand mouse button on run.
Insert disk #1 into the floppy drive - probably drive A.
Write “A:\Setup” and press “Enter”
The program will then lead you through the installation. Insert
disk #2 and #3, when requested to do so.
When the installation is complete, close Windows before starting
the program. The installation process creates an icon - called
MaxCal III. Start the program by double clicking this icon.
Windows 95 users should note that the program cannot start unless
a printer driver has been installed!
11.3 Connecting MAXICAL
®
III to the Computer
MAXICAL
®
III is programmed solely by means of serial data
transmission between MAXICAL
®
III and the computer. The
connection can be either the optical read-out head, type no. 66-99-
102, or a data cable with built in RS-232 adaptor, type no. 66-99-
106, connected to the screw terminals 62-63-64 at the rear of
MAXICAL
®
III.
